单开口端的聚丙烯盒

单开口端的聚丙烯盒

    Single open end (SOE) systems have a maximum differential pressure of 60 psi. They are autoclavable at 250°F (121°C) and in-line sterilizable (except where noted) at 261°F (127°C). SOE cartridges have a 222 O-ring configuration to create a tight seal to prevent seepage. Use sump extension adapter kit (sold below) to fit cartridges into housings.Serial-layer magna nylon cartridges have two pleated nylon membranes—top acts as a prefilter. High retention capacity and high yields. 
    Glass fiber cartridges contain interwoven borosilicate glass microfibers held by acrylic binders for exceptional retention. Use as a prefilter to protect membrane filter systems. Not in-line sterilizable. 
   Polypropylene (PP) cartridges have a single-layer filter media. Chemically inert with high dirt-loading capacity. Use as a prefilter for aqueous solutions. Hydrophobic; prewet* before use. Not in-line sterilizable. 
    PTFE membrane cartridges have a single layer, pleated PTFE membranes laminated to a PP support. Use for gas filtration and venting. Hydrophobic and inert; prewet* when filtering aqueous solutions. 
    Semiconductor cartridges have a single-layer PES membrane. Each is flushed with 18 M? water to assure downstream cleanliness and rapid resistivity recovery. Diffusion rate of 12 mL/min at 30 psi.

   单一的开放端部（SOE）系统有一个最大的差压力为60psi。可高温高压灭菌，在250°F（121°C）和在线灭菌的（特别注明除外）在261°F（127°C）。国有企业的墨盒有222 O型圈配置，以创建一个严密的密封，防止渗水。使用油底壳扩展适配器套件（另售），以适应麦格纳尼龙到housings.Serial层墨盒的墨盒有两个褶尼龙膜顶  

   作为预过滤器。高保留能力和高产量。 
   玻璃纤维盒含有硼硅玻璃微纤维交织丙烯酸粘合剂，特殊的保留。使用保护膜过滤系统预过滤器。不在行消毒。 
  聚丙烯（PP）的墨盒中有一个单一的层的过滤介质。化学惰性，高污负荷能力。使用作为一个预过滤器的水溶液。疏水性; *使用前预湿。不在行消毒。 
PTFE膜滤芯具有单层，打褶的PTFE膜层叠的PP的支持。用于气体过滤和通风。疏水性和惰性;预湿*过滤水溶液时， 
   有一个单层的PES膜半导体墨盒。每冲洗的18 M？水，以保证下游的清洁和快速电阻率恢复。在30psi 12 mL / min的扩散率。