Masterflex® 77122-26 Ç/ L ®软管泵变速的50〜300转，12 VDC

Masterflex®Ç/ L ®软管泵变速的50〜300转，12 VDC

Masterflex® C/L® Variable-Speed Tubing Pump; 50 to 300 rpm, 12 VDC

新头管设计提供了更精确，改进流动性能

流量：0.002至43毫升/分钟，取决于驱动器转速和泵管尺寸

聚苯硫醚（PPS），聚甲醛，共聚聚酯泵头与四个不锈钢（SS）的辊

“最大”按钮运行泵最大转速或迅速冲洗管。

可堆叠，紧凑1/4-DIN外壳安装在设备机架或您的实验室台上。（安装，订购支架77120-03）。

泵接受一个干净的，不间断的流路，没有配件的连续油管的长度。

独立的单圈速度控制和连续波 /关闭/ CCW开关带绿色LED电源指示灯保持速度设定，当你打开泵开/关或扭转方向。

可逆永磁直流电动机，清洗液之前或之后抽泵流体在任一方向。

泵的背面远程控制连接，触点闭合开始/停止泵

“最大”按钮运行泵最大转速或迅速冲洗管。

泵头平均固定管闭塞，没有需要调整改变管闭塞时。

C / L泵结构紧凑（1/4 DIN）和低流量OEM使用或分析仪应用的完美。这些易于使用，经济泵具有可逆抽水，远程控制能力，快速更换泵管。色谱，光谱，一致的流体输送和分配应用的理想选择。

最大吸程5英尺（1.5米），20英尺（6.1米）的最大放电头，最大压力为15 psi（1.0巴）。自吸泵承受轻微的背压。

包括： 5英尺（1.5米）0.89毫米ID聚乙烯的® LFL油管。基于化学相容性和流速，订购额外的微孔管。

New head design provides more positive tubing retention and improved flow performance

Flow rate: 0.002 to 43 mL/min depending on drive rpm and tubing size

Polyphenylene sulfide (PPS), acetal, and copolyester pump head with four stainless steel (SS) rollers

Max button runs pump at 100% of maximum rpm—use to prime or to rapidly flush tubing

Stackable, compact 1/4-DIN housing—mount in your equipment rack or place on your lab bench. (To mount, order brackets 77120-03).

Pumps accept continuous lengths of tubing for a clean, uninterrupted flow path with no fittings.

Separate single-turn speed control and cw/off/ccw switch with green LED power indicator—maintain speed setting when you turn pump on/off or reverse direction.

Reversible permanent magnet DC motor; purge fluid before or after pumping; pump fluid in either direction.

Remote control connections on back of pump; start/stop pump with a contact closure.

“Max” button runs pump at maximum rpm—prime or rapidly flush tubing.

Pump head has average fixed occlusion for tubing; no need to adjust occlusion.

C/L pumps are compact (1⁄4 DIN) and perfect for low-flow OEM use or analyzer applications. These easy-to-use, economical pumps feature reversible pumping, remote control capabilities, and rapid tubing changes. Ideal for consistent fluid delivery in chromatography, spectroscopy, and dispensing applications.

Maximum suction lift of 5 ft (1.5 m); max discharge head of 20 ft (6.1 m); max pressure 15 psi (1.0 bar). Self-priming pumps withstand minor back pressure.What's included: 5 ft (1.5 m) of 0.89-mm ID Tygon® LFL tubing. Order additional microbore tubing based on chemical compatibility and flow rate.